ID-Nr. 0000065892: Professional in QA/QC Engineering (Oil and Gas) with TÜV Rheinland certified Qualification

Die vorliegende ID Page ist auch in folgenden Sprachen verfügbar: Englisch
Titel des Zertifizierungsprogramms:Professional in QA/QC Engineering (Oil and Gas) with TÜV Rheinland certified Qualification
Zulassungsvoraussetzungen:
  • Bachelor of Engineering (B.E.) /
  • Bachelor of Technology Mechanical, Production or Chemical Engineering
  • Diploma in Mechanical Engineering
  • Working professional with at least 2 years’ experience in domain subject
  • Successful participation in the United NDT training course “Professional in QA / QC Engineering (Oil & Gas)’ recognized by PersCert TÜV.
  • Admission to the exam is granted upon a minimum attendance of 80% of the total 270 hours teaching units.
Prüfungsbausteine:
  • Written exam (Multiple Choice and Open Questions)
  • Oral exam
  • Practical exam
Nachzuweisende Kompetenzen:

In the examination participants prove their knowledge in the following areas:

  • Welding
    • Ability to perform visual inspection
    • Good knowledge of welding symbols and drawings
    • Performance of inspections before, during and after welding
    • Ability to qualify welding procedures
    • Ability to do documentation as per the inspection.
  • Piping
    • Knowledge of Isometric ,GAD & P and ID Drawings
    • Ability to perform according to the specification requirements
    • Ability to perform fabrication on the basis of the drawings
  • Non Destructive Testing
    • Ability to perform NDT Inspection (VT,MPT,UT,RTFI)
    • Ability of Film Interpretation
    • Ability to perform calibration
  • Coating
    • Ability to inspect environmental conditions
    • Comparison of PDS and specification
    • Calculation of DFT
    • Inspection of Surface profile (visual)
    • Inspection after coating (visual)

Successful candidates are in a position to:

  • Perform material inspection (Visual inspection of incoming materials)
  • Perform piping and structural inspection based on several drawings
  • Read P & ID & Isometric Drawings
  • Perform welding inspections (inspection before, during & after welding)
  • Carry out non-destructive testing (PT,MT,UT)
  • Perform NDT inspection
  • Perform pressure testing
  • Perform coating inspection
Rezertifizierung:

In a recertification process participants have to prove that their expertise is up to date.

Kooperationspartner:United NDT Training & Inspection Centre
Bisher umgesetzt in:Indien