|Certificate/Reg.-No.||V 72 2014 C11|
|Type of Certificate||A-FS&CS Certificate|
|Certificate Holder||Asco Joucomatic SA|
|Manufacturer||Asco Joucomatic SA|
|Product Category||Actuators > Valves|
|Subject||Solenoid Control Valve with Safety Function|
|Type Designation||126 00 ... and 126 60 ...|
|Codes and Standards||
|Scope and Result||Valve type, if used in a design with a Hardware Fault Tolerance (HFT) of 0, is suitable for operation in safety related systems with a Safety Integrity Level (SIL) of up to and including SIL 2.
If a HFT of 1 or even higher is established the valves are usable in a safety related system up to SIL 3.
The safety function is to open their lower port and close their upper port when de-energized and to vent the equipment connected to the middle port.
|Specific Provisions||The suitability for certain fields of application can only be assessed by additional evaluation of further components of the subsystem. According to IEC 61511-1 a HFT = 0 for SIL 3 rated systems is not allowed.
The instructions of the associated Installation and Operating Manual shall be considered.
Summary test results see appendix.
|Valid Until||2019-07-17 (Certificate expired)|
|Appendixes||Annex V72 2014 C11.pdf|
|Certificate/Reg.-No.||Certificate Holder||Product Category||Product Tested||Type Designation||Details|
Remark: In case of missing entries this is due to restrictions by the certificate holder